|
|
|
|
|
|
|
|
|
|
|
|
I want to thank you for your quick response in getting the part I ordered to me. I received it on Friday 11/05
and installed it the next day. It works just fine and when my wife is happy everyone in this house is happy.
Thanks again,
Loren P.
Installation successfully completed. Thanks for your support and the nice merchandise. We like the new racks better than the originals. Your prices are also more
reasonable than the competition, for essentially the same products. Happy to provide an endorsement, if you use them.
Dave
|
enter your Model number or Part number
and then click on "Search" button
|
Appliance Repair /
Error Codes, Fault Codes
|
ASKO Error Codes, Fault Codes
ASKO - Dishwasher
|
Failure Code
|
Condition
|
Check/Repair
|
|
F1
|
Water heating fault, chosen temperature not reached within 60 minutes
|
· Incoming water temperature is cold
· Heating element burned out
· Thermostat not working
|
|
F2
|
High water level
|
· Plugged or bad water pump
· Defective water inlet valve
|
|
F3
|
Thermostat fault
|
· Open thermostat
· Bad wiring to thermostat
|
|
F4
|
Fault with water fill
*only on machines with level-controlled fill
Note: Pump running, lights blinking and controls dead indicates
an over fill fault
|
1. Disconnect the power
2. Remove the lower access panels and check the tray under the dishwasher
3. Remove the water
4. Check if the pump is working.
5. Test the dishwasher
6. Check the drain hose under the sink if there is no leak from the dishwasher
7. The drain hose must run up to the top of the underside of the countertop than
down to the drain.
*Faults may vary by model. Apply this as a general guide.
|
Search for Asko Appliance Parts
ASKO - Dryer
|
Failure Code
|
Condition
|
Check/Repair
|
|
F1
|
Overfilled Condensate drain
|
Inspect condensate reservoir pump and drain tube.
|
|
F2
|
Maximum drying time exceeded, about 3 hours.
|
· Inspect for tripped circuit breaker or blown fuse
· Inspect ductwork for lint build-up
· Inspect hi-limit and cycling thermostat
· Inspect heating element
|
|
F3
|
Fault Thermistor
|
· Open thermistor, recommended to replace thermistor
·Thermistor improperly wired
|
|
F4
|
Large amount of lint in the lint filter, front housing, or in the condenser
|
Clean lint from lint filter and condenser
|
|
F5
|
Moisture sensor is in fault
|
· Lint covering sensor in front of housing
· Not working sensor
· Sensor improperly wired
|
Search for Asko Appliance Parts
ASKO - Washing Machine
|
Failure Code
|
Condition
|
Check/Repair
|
|
F1
|
Water supply or low water fill
|
· Inspect water supply · Recommended to replace water inlet valve
|
|
F2
|
Water level is too high
|
· Water pump plugged/Bad
· Faulty water valve
|
|
F3
|
Pump trouble
|
Verify pump trap and clean.
|
|
F4
|
Thermistor trouble
|
· Open thermistor, Recommended to replace thermistor
· Thermistor improperly wired
|
|
F5
|
Fault in thermal cutout or heating pause fault. Chosen temperature not reached in
90 minutes
|
· Inspect heating element
· Inspect thermostat
|
|
F6
|
Motor fault
|
· Inspect wiring to motor
· Recommended to replace motor if necessary
|
|
F7
|
Door lock release fault
|
· Bent pull-rod for door latch
· Door latch solenoid bad
|
|
00 00
|
Machine doesn’t spin
|
Check load for out of balance reallocate load and restart
|
Search for Asko Appliance Parts
|
|
Lowest Price
|